Yamaha Revolabs FLX2 System Manual page 46

Recent Calls ON / OFF
The Recent Calls option allows you to enable or disable logging of the recent calls. If
you switch Recent Calls OFF the list of the recent calls will be erased and no future
information on recent calls will be kept in the system.
Pairing
All FLX2 wireless components are paired before the system is
shipped, providing much of the system setup already
completed. While pairing should not be required for the system
to work, sometimes components can require pairing if a part is
shipped separately.
The following are instructions on how to pair the wireless
components of the system to the FLX2 Conference Phone. All
components are paired to the Base, which is the central unit
that communicates with all other components. To pair a
Microphone or a Speaker to the FLX Conference Phone, a FLX
Dialer has to be paired first. If several components need to be
paired, or a whole system needs to be paired, start with the
FLX Dialer.
Dialer
1. Turn off the Dialer by pressing and holding the red 'end call' button until an
overlay appears asking whether you want to shut the Dialer down. Press 'Yes'.
2. Plug in the FLX2 Base Station.
3. Turn the Dialer back on (press the red 'end call' key). The screen should read
"Scanning for new base". If the screen reads "scanning for paired base", press
the 'Stop' button, press the 'Menu' button, navigate to "Advanced', and select
'Re-Pair'. When asked whether to 'Scan for New Base', select 'Yes'.
4. After some time scanning for available bases, an overlay will appear asking 'Pair
with <System Name>?' The system name is either the Factory preset name of
RevoFlx_xxxx, with xxxx the last four digits of the BT number on the bottom of
the Base station, or the system name you previously selected in the Advanced
Setup. Select 'Yes'.
5. An overlay, 'Pairing with base <System Name>', should appear followed by a
'Connecting...' and then an 'Initializing...' screen. Shortly after that the Dialer
home screen will appear. Your Dialer is now paired.
6. If the Dialer does not automatically pair, repeat steps 1-5. If this still does not
resolve the problem, select "Reset Factory Defaults" (under the Advanced Menu)
as this will force a scan for a new base.
Speaker
1. To pair a Speaker first turn it off by pressing and
holding the button on the bottom of the Speaker until
you hear the Speaker shut-off or the LEDs turn off.
2. Ensure that the Base Station is plugged in and powered
up.
46