Step2: Enter Wheel Circumference - Oregon Scientific OUTBREAKER RX107 Series User Manual

Table of Contents

Advertisement

To attach the equipment:
1. Attach the bike mount to the right or left handlebar using
rubber grip, nut and bolt provided. Tighten until the bike
mount is fixed into place, using the rubber grip for a firmer
contact.
2. Attach the cadence sensor to a stationary point just behind
the pedal, using the rubber grip for a firmer contact. There
should be maximum
39 inches (100cm)
and the bike mount, and less than 30 degrees vertical angle.
3. Attach the cadence magnet to a pedal so that it is directly
aligned with the sensor with less than
between.
4. Attach the speed sensor to either leg of the front forks, using
the rubber grip for a firmer contact.
maximum
39 inches (100mm)
39 inches bike mount, and less than 30 degrees vertical
angle.
5. Attach the speed magnet on a spoke of the front wheel so
that it less than
0.2 inches (5mm)
6. Check and adjust as necessary, then snip the ends off the
clips so that no excess remains.
7. Fit the watch into the bike mount.
8. Press MODE on the watch to switch to BIKE Mode.
9. Press ST/SP/- to activate signal reception. The display
shows "- -", then changes to 0 once a successful signal is
received.
10.Ride the bike a short distance to make sure signals are being
sent to the watch successfully.
11.You are now ready to begin your trip.
between the sensor
0.2 inches (5mm)
There should be
between the sensor and the
from the sensor.
NOTE
The watch can work with one or both sensors.
NOTE
When the display shows a low battery icon
'Battery' section) replace the battery for the corresponding unit.
STEP 2: ENTER WHEEL CIRCUMFERENCE
You must set the bike's wheel
circumference on the watch so it can
accurately calculate your speed and
distance. If you do not know the bike's
wheel circumference, you can check the
manufacturer's specifications or measure
it by marking the wheel where it touches
the ground, and then rotating the wheel once fully along the
ground. Measure the difference between the two marks.
NOTE
Most wheels have their specifications written on them.
To specify this information on the watch:
1. Press MODE to switch to the BIKE Mode.
2. Press and hold FUNC/SET for 2 seconds.
3. Press SELECT/+ or ST/SP/- to change the circumference
(cm or inches, depending on the measurement unit you
selected in CLOCK Mode).
4. Press FUNC/SET to save your changes.
NOTE
You can also use the PC software for this operation (see
PC section).
21
(see

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rp107r

Table of Contents