Table of Contents
Advertisement
Control Panel
2
1
NOTE: Total power drawn from all receptacles must not exceed the name plate rating.
1
Engine Start Switch – Used to start engine
from the starter motor(Electric start model
only). To start engine, press and hold the
switch in the "START"(ll) position, the
engine will crank and attempt to start. When
the engine starts, release the switch to the
"RUN"(l) position.
2
4-1 Data-Minder(Multi-Meter) – Push the
SELECT button to show the Voltage, Hertz and
running hours. If the low oil indicator is lit,
check the oil level.
A - Digital display
B - AC voltage indicator
C - Frequency indicator
Battery Switch – Power the electric starter.
3
4
Remote Start Indicator Light - The light
will light or flash depending on the status of
the remote start system.
Remote Start Program Button
5
button along with the remote control to program
the generator to be started remotely. Your remote
control is already programmed in factory for your
convenience. You might need programming when
using new remote control.
6
120/240V, 50A RV – (NEMA 14-50R)
Maximum full load current may be drawn from this
120/240 Volt, 50 Amp receptacle.
English
4 5
3
D - Hour indicator
E - Low oil indicator
F - Select button
- Use this
12
6
12
120/240V, 30A Twist-Lock – (NEMA L14-30R)
7
Maximum full load current may be drawn from this
120/240 Volt, 30 Amp receptacle.
120V, 30A Twist-Lock (NEMA L5-30R)
8
30 Amp current may be drawn from this 120 Volt
receptacle.
9
120V, 20A Duplex – (NEMA 5-20R)
20 Amp current may be drawn from this 120 Volt
receptacle.
Ground Terminal – Consult an electrician
10
for local grounding regulations.
Outlet Cover - Protect the receptacles from
11
dust and debris.
12
Page 10
8
7
11
10
Customer Service: 1-844-FIRMAN1
9
Advertisement
Table of Contents
