Installer Menus - Zenith H27E46DT Installation And Operating Manual, Warranty

Installer Menus

Use the Installer Menus to change operational settings
Accessing the Installer's Menu
Installer's menus can be accessed by using the installer's remote control. Just press
and hold MENU (about 8 seconds) until the display changes, then press 9, 8, 7, 6,
then ENTER. To exit the Installer's Menu, press ENTER again. Any changes you make
will be stored in nonvolatile memory.
The Installer's Menu opens with item 04, VERT POS. Press the SELECT key to sequence
through the various items. Or, access an item directly by entering the line number,
then pressing MENU. For example, to access the Start Channel option which is on line
11, press 11, then MENU. To change a setting use the Left/Right ADJ keys.
Using the Installer's Menu
Items 00-30 are immediately accessible only upon entering the Installer's Menu.
Their numbers, descriptions, ranges, factory default settings, and a place for listing
any changes made on-site are given below. A second section of the Installer's Menu
that is intended for qualified service technicians only is not shown (items 31-219).
Normally these items do not require adjustment.
Items in the Installer's Menu:
Item Description
00 FACT MENU
01 PRESET PX
02 PRESET AX
03 POWER MANAGE
04 VERT POS
05 HORZ POS
06 BAND/AFC
07 MIN VOLUME
08 MAX VOLUME
09 AC ON
10 KEY DEFEAT
11 STRT CHANNEL
12 STRT VOLUME
13 NOT USED
14 CHAN LOCK
15 GHOST CH.
16 NOT USED
17 TEXT MODE
18 SLEEP TIMER
19 ALARM
20 CH. OVER RIDE
21 OLD OCV
22 CAPTION LOCK
23 FUNCTION PRE
24 FEATURE LEVEL
25 NTSC SCAN CARD
26 NOT USED
27 MUTE DISABLE
28 V-CHIP
29 MAX BLOCK HOURS
30 STRT AUX SRCE
P A G E 4 0
Range Fact. Set
0 - 1 0
0 - 1 1
0 - 1 1
0 - 7 0
0 - 30 15
0 - 45 15
0 - 7 0
0 - 63 0
0 - 63 63
0 - 1 0
0 - 1 0
0 - 255 255
0 - 63, 255 255
0 - 1 0
0 - 1 0
0 - 1 0
0 - 3 0
0 - 1 1
0 - 1 1
0 - 1 1
0 - 1 1
0 - 1 0
0 - 1 0
0 - 1 0
0 - 1 1 Zen 1/0 P Lbl
0 - 1 0
0 - 1 0
0 - 1 0
0 - 1 1
0 - 99 12
(0)/1-5/255 255
1391-P07 01.47
4 VERT POS 13
XX/XX/XX TE = 10110000
Installer should leave item
00 FACT MENU set to 0
(default). Items 31-219 are
service-type adjustments and
only qualified technicians having special-
ized test equipment should access them.
Recommended Setting
Leave default set 0
Leave default set 0
Leave default set 0
Leave default set 1 (1 Zen 1)
02
206-3492-O