Computer Hookup - Zenith H27E46DT Installation And Operating Manual, Warranty

Computer Hook Up
Here is the basic setup to use the Presentation TV as a
computer monitor
1
Make the basic connections as indicated.
(Appearance of components may vary from
those in the illustrations.)
2
Plug in your TV. The Presentation TV is
designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to
operate it on DC Current.
3
Set the computer's image output settings to
800 x 600 @ 60Hz or SVGA.
4
Using the Source menu, highlight "REAR
COMPUTER SVGA" (Rear Computer in) or
"FRONT COMPUTER SVGA" (Front Computer
in) then press ENTER on the remote to
change to the computer image source.
5
Boot up your computer. As it warms up,
the TV will adapt to your computer.
Note: Unlike a computer monitor, this TV
does not show a computer image on the
screen until the TV has completely adapted
to your computer's output. This is normal
when using this TV as a computer monitor.
When the TV has completely adapted to your
computer, the computer's image will appear
on the screen.
Components may vary from those in the illustration.
If you have a Macintosh, use the 2-row to 3-row DB15
adapter on the Macintosh video connector.
On some notebook models, you must locate the "display
toggle key" and switch the display to "external." Refer
to the instructions for your computer.
206-4543
Computer Video "Card"
Output
Video Out to
Computer
Monitor
Back of
Computer
"Video Mirror"
Cable
COMPUTER
IN
Connections to TV front or rear computer port,
TV Front
video in
Computer Sound
"Card" Output
TV Back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN
VIDEO
AUX IN
M.P.I.
R
AUDIO OUT
COMPUTER
L
AUDIO
with computer sound card output
to front or rear R - audio - L inputs.
L audio R
R- AUDIO- L
R- AUDIO- L
R- AUDIO- L
P A G E 7