Other Storage Tips; Battery Service; Battery Replacement (Xg7000E & Xg8000E) - Generac Power Systems XG8000E Owner's Manual

6,500-8,000 watt
Table of Contents

Advertisement

Available languages

Available languages

3.8 OTHER STORAGE TIPS

Do not store gasoline from one season to another.
Replace any gasoline can that starts to rust. Rust and/or dirt in
the gasoline will cause problems with the carburetor and fuel
system.
If possible, store the unit indoors and cover it to give protection
from dust and dirt. Cover the unit with a suitable protective
cover that does not retain moisture.
BE SURE TO EMPTY THE FUEL TANK.
to empty the fuel tank and the unit is to be stored for some
time, use a commercially available fuel stabilizer added to the
gasoline to increase the life of the gasoline.
NEVER cover the generator while engine and
exhaust area are warm.
4.1 BATTERY REPLACEMENT
The battery shipped with the generator has been fully charged.
A battery may lose some of its charge when not in use for
prolonged periods of time. If the battery is unable to crank
the engine, plug in the 12V charger included in the accessory
box (see the Charging a Battery section). RUNNING THE
GENERATOR DOES NOT CHARGE THE BATTERY.
The battery shipped with the generator has been provided fully
charged. To replace the battery (See Figure 16):
Remove the side panel as shown. Remove the four bolts
securing the fuel tank.
Turn the fuel valve on the control panel to the "OFF" position.
Pull the fuel tank back slightly and remove the fuel hose that
runs from the engine to the fuel valve.
Drain fuel into approved container outdoors, away from
open flame. Be sure engine is cool. Do not smoke in the
vicinity or light a cigarette.
Push the fuel valve from the control panel and remove the fuel
tank.
Remove the battery wire connections (black wire first) and the
battery hold-down bracket.
Replace the battery, connecting the RED wire to the POSITIVE
(+) terminal and the BLACK wire to the NEGATIVE (-) terminal
Start all four screws on the side panel before tightening or it
may not be possible to get all the screws in place.
If it is not practical
(XG7000E & XG8000E)
NOTE:
NOTE:
Figure 16 – Battery Removal
ENGINE
STARTING
BATTERY
SIDE
PANEL

Battery Service

FUEL TANK
ASSEMBLY
BATTERY
BRACKET
15

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents