Table of Contents
Advertisement
Two levels of access rights may be assigned:
Read
Read/Write
Note: Do not set all the stations in the Access Control table to Read only. Once this
is set and enabled, it will be impossible to modify the outdoor bridge. Should
this situation occur, you need to restore the outdoor bridge to the factory
configuration by using Kick Start (see FAQs for details).
To set a stations' access right, enter a station's IP address and password and choose
Read or Read/Write.
When a setting is made, click OK. Repeat the procedure for the next station. When
all settings are made, click OK in the configuration dialog box to make the changes
effective.
Trap Server
When the outdoor bridge is powered on, or an Ethernet port becomes active, an event
log will be generated indicating the time, the IP address of the reporting outdoor
bridge, and the event. You can view and save the event logs from the station as a
Trap Server.
To assign a trap server, click Trap Server (Figure 21).
26
Read-only rights. The user may read everything
except the Access Control settings, but is not
allowed to alter anything
The user may read and alter all settings
11-Mbps Wireless Outdoor Bridge
Advertisement
Table of Contents
