Download Table of Contents Print this page

Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi KC18DBFL2S Safety Instructions And Instruction Manual

Advertisement

Table of Contents

APPLICATIONS

<DV18DBFL2>
○ Use as a hammer drill
Drilling of soft bricks and concrete blocks.
<DS18DBFL2 / DV18DBFL2>
○ Use as a drill
Drilling of soft steel, wood, plastic and aluminum
materials.
○ Use as a screwdriver
Tightening and loosening of machine screws, wood
screws and tapping screws.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 5).
Latch
Battery
Pull out

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.

ASSEMBLY AND OPERATION

Handle
Push
Insert
Fig. 5
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted
into the receptacle, pilot lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
Fig. 6.
Pilot lamp
Charger
3. Charging
When the battery is inserted into the battery charger,
charging will commence and the pilot lamp will light in
red. (See Table 2)
NOTE
If the pilot lamp does not light or blink in red, pull out
the plug from the receptacle and check if the battery
is properly mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 2, according to the condition of the charger or
the rechargeable battery.
English
Battery
Fig. 6
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dv 18dbfl2Ds 18dbfl2Ds18dbfl2qb

Table of Contents