Installation Menu; Lamp Mode; Keystone - Runco VX-1000c Owner's Operating Manual

Installation Menu

Installation Menu
The Installation menu is where you can adjust the Picture Orientation,
Keystone, Lamp Output, and even check the age of the lamp in the
Projector.
When the PFP Controller is turned on for the first time, the INSTALLA-
TION item will not appear in the main menu. To enable the INSTALLA-
TION menu, there are two options:
· With the processor ON and no menus on-screen, simultaneously press
the ENTER, UP and LEFT buttons (you don't need to hold them down).
Release the three buttons and press MENU, ensure INSTALLATION is
now on the bottom of the main menu.
· With the remote control, press button 6 (with no menus on-screen).
After pressing '6', press MENU and ensure INSTALLATION is now on the
bottom of the main menu.
After INSTALLATION has been accessed, press MENU, highlight
INSTALLATION and press ENTER. This will bring up the INSTALLATION
MENU, shown on the right:

Lamp Mode

The Lamp Mode enables the installer to set the lamp for full brightness (normal) or Low (20% lower).
If a small screen is being used in a dark area or the image is otherwise too bright, it may be a good
idea to set the Lamp Mode to LOW. When the Lamp Mode is set to LOW, the lamp will last longer as
a result of the lower current setting.

Keystone

KEYSTONE: Corrects the trapezoidal distortion that results from projecting at an angle:
An image with Keystone error
This may occur in installations where the projector needed to be angled as a result of a larger vertical
offset. This keystone feature will correct for trapezoidal distortion for as much as a 15° projector angle.
A correctly adjusted image
21
INSTALLATION
Lamp Mode
Keystone
Picture Orientation
IR Code Set
Lamp Hours 20