Runco VX-1000c Owner's Operating Manual page 31

COMMAND PARAMETER
!STORE
!RESTORE
!FACTORY
!STATUS
!RESTART
!ECHO
!NOECHO
!INSTALLMODEOFF
!INSTALLMODEON
!SERVICEMODEON
!SERVICEMODEOFF
RGAIN
GGAIN
IRCODE
IRCODE
IRCODE
IRCODE
IRCODE
Value stored?
(min/max)
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
-30/30
-30/30
013
215
510
918
0
29
DESCRIPTION
YES Stores the current set of values
(all values) into non-volatile
memory
YES Restores the stored values
YES Restores all values to factory
default levels
NA Asks the Controller to provide
the hardware information,
current values and system status
to the automation system
NO Restarts the PFP Controller
(same as turning it on and off)
NO Enables the Controller to echo
back commands and values to
the automation system
NO Disables the PFP Controller's
character echoing
NA Disables the Installation menu
(removes it from the main menu)
NA Enables the Installation menu
(enables it on the main menu)
NA Enables the service mode
NA Disable the service mode
NO Adjust the Red level of image
NO Adjust the Green level of image
NO Changes the IR Code Set of the
Controller to 013
NO Changes the IR Code Set of the
Controller to 215
NO Changes the IR Code Set of the
Controller to 510
NO Changes the IR Code Set of the
Controller to 918
NO Disables the IR receiver