Adjusting The Balance; Preparing The Fuel - Shindaiwa B410S Operator's Manual

Adjusting the balance

Adjusting the shoulder harness
 This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons. Do
not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
 A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some
persons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
Balance tool for a level plane of cutting head rotation

Preparing the fuel

 Do not fuel up while the engine is hot or in operation.
 Do not smoke or hold a flame near when refuelling.
If you do so, the fuel could ignite and cause fire, leading to burns.
 Do not fill fuel tanks indoors. Always fill fuel tanks outdoors over bare ground. Do not refuel the product on the load-
ing platform of a truck, or in other such places.
 Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.
Otherwise, fuel may get spewed.
 Mop up any fuel that overflows or spills out due to overfilling.
Fuel spills can cause fire and burns when ignited.
 After refuelling, always check that there are no leaks or discharges of fuel from the fuel pipe, fuel system grommets,
or around the fuel tank cap. If you do find fuel leaks or discharges, stop using the product immediately and contact
your dealer to have it repaired.
Any fuel leaks could cause fire.
 Keep the refuelling tank in a shaded area away from fire.
 Use an approved fuel container.
 Fuel is a mixture of regular grade petrol and an air-cooled 2-stroke engine oil. Minimum 89 Octane unleaded petrol is recom-
mended. Do not use fuel containing methyl alcohol or more than 10 % of ethyl alcohol.
 Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days.
WARNING
IMPORTANT
 The accompanying shoulder harness is suitable for people of
standard adult physique, who are 150 cm - 195 cm in height
and 60 cm - 140 cm in waist size.
 Use a shoulder harness when provided or when recommend-
ed in this manual. Adjust both harness and the suspension
point (A) on the unit so the unit hangs with the cutting attach-
ment a few centimetres above ground level (B).
 The cutting attachment and shield should be level in all direc-
tions. Harness the unit on the right side as shown.
DANGER
WARNING
IMPORTANT
11
Before you start