Zoom WL1095 Series User Manual page 61

Static Routing: For static routing, you can specify up to 8 routing rules. You can enter the
destination IP address, subnet mask, gateway, hop for each routing rule, and then enable or
disable the rule by checking or unchecking the Enable checkbox.
Example:
Configuration on NAT Router
Destination
192.168.1.0
192.168.0.0
So if, for example, the client3 wanted to send an IP data gram to 192.168.0.2, it would use the
above table to determine that it had to go via 192.168.123.103 (a gateway),
And if it sends Packets to 192.168.1.11 will go via 192.168.123.216
Each rule can be enabled or disabled individually.
After routing table setting is configured, click the save button.
SubnetMask
255.255.255.0 192.168.123.216
255.255.255.0 192.168.123.103
61
Gateway Hop
1
1
Enabled
ˇ
ˇ