Advertisement
8.
Position Plywood so it sits almost flush with outside of floor joist framing (see Note). When correctly
positioned, attach to all floor joists with approximately 24 - 1 1/4" Screws. Use screws every 16".
B. Wall Section
Wall Extendors (2)
Extendor Top Siding
piece (2)
Angled Wall
Extendors (2)
Extendor Wall
Cleats (2)
3/4" thick Filler Trim
Door Jamb
Door Header - Long
9.
Locate 5 Solid Wall Panels and 5 Wall Plates (1 1/2" x 2 1/2" x 45 1/2"). Attach Plates to
bottom of studs of each wall panel with 3 - 2 1/2" Screws. Position so plates are flush with framing.
Toll Free 1-888-658-1658
Note: Plywood is cut slightly smaller than
floor framing. Keep plywood seams tight.
Exploded view of all parts necessary to
complete the Wall Section. Identify all parts
prior to starting.
Solid Front Wall
Panel - 73" high
Wall Plate (5)
Important:
Pilot hole ALL 2x3 Wall
Studs with 1/8" drill bit prior to
screwing. This will make it much
easier to attached together.
Wall Plate
www.outdoorlivingtoday.com
Page 9
Horizontal
Wall Cleats
Door Header
- Short
Solid Wall
Panel (4)
7/8" thick Filler Trim
Pilot Hole
sales@outdoorlivingtoday.com
first.
Advertisement
