Advertisement
Bottom of bracket flush with
bottom of Door Header.
56.
Once track is evenly spaced from side-to-side (approximately 12" from bracket to wide trim on
both sides) and bottom of bracket is flush with bottom of header, attach with 1 - 1 1/2" Torx Screw
per bracket to hold in place. Attach 2nd bracket with another 1 1/2" Torx Screw. Check level once
again. Complete attachment of remaining Torx Screws on brackets of Track.
Door Stop
57.
Locate Sliding Door and flip over onto a clean, dry and level spot. Position Door Stop
(1 1/2" x 2 1/2" x 66 7/8") on left inside frame of door as shown above. Position 1" from outside
trim of door as shown above. Attach with 3 - 2 1/2" Screws into horizontal door framing.
Toll Free 1-888-658-1658
Attach 1 Torx Screw per bracket to hold
in place while aligning track.
www.outdoorlivingtoday.com
Page 28
sales@outdoorlivingtoday.com
Advertisement
