Advertisement
65.
Locate and identify all Facia pieces: Front & Rear Facia (4 @ 1/2" x 4" x 50 1/2").
Side Angle Cut Facia (2 @ 1/2" x 4" x 54 1/8"). In front corner, align side and front Facia together.
Front facia will cap side facia.
Front caps
side facia.
66.
Do a dry run first before securing. Position Front Facia up underneath roof panel and against
rafter ends. Have your helper hold in position. Place angle cut Side Facia underneath roof panel
against Rafter/Facia Nailing Strip. Align so Front Facia caps Side Facia and then attach the front
with 6 - 1 1/2" Finishing Nails. Attach side with 5 - 1 1/2" Finishing Nails securing them into the
nailing strip (closer to the top of the side facia board). Attach next piece of Front Facia. Note: With
Front Facia correctly aligned at corners, a small gap may occur at center seam. This will be covered
by Facia Detail Plate in Step 70.
67.
Place and align rear and side facia for best possible fit with rear capping side facia. Attach facia
to rafter ends with 6 - 1 1/2" Finishing Nails per piece. Complete both rear facia pieces.
Toll Free 1-888-658-1658
Front
Side Angle
Facia
Cut Facia
www.outdoorlivingtoday.com
Page 33
Rafter/Facia Nailing Strip
Small gap
may occur.
sales@outdoorlivingtoday.com
Advertisement
