Low Battery Alarm - Maxcom MM910 Instruction Manual

4. When the battery is completely charged, disconnect
the charger from the wall socket and then the cable
from the phone.
When the process of battery charging is finished, the
display will show the following message „Charging
completed", and the battery symbol will not pulsate.
Note:
o
Before charging the battery make sure that the
battery is correctly installed.
o
During battery charging do not remove the
battery–it may cause the phone damage
If the voltage of the battery is too low to make the
phone operate correctly, the display will show the
message that the phone will be automatically
switched off and then the phone will be
automatically switched off.
o
If the battery is completely discharged (for
example because of the torch being switched on),
after connecting the charger, wait a few dozen
minutes before charging symbol appears

Low battery alarm

The phone will generate a sound signal (if warning sounds
are activated in profiles) together with the following
message: „Battery discharged" when the battery level will
be too low. The display will show
when this message will appear.
14
Charge the battery
.