Intellian v100NX Installation & Operation User Manual page 55

NOTE. A
The "Cable Compensation Range" is determined by the condition of installation (Modem, BUC). There
exist four cases of cable compensation as follows.
Case Modem*
1 iDirect
2 iDirect
3 iDirect
Not use
NOTE
4
iDirect
*Modem: iDirect X5, X7 Series which are able to access Telnet and support CLI.
**BUC: NJRC, Terrasat products which have M&C function.
NOTE. B
The "Attenuator Graph" displays attenuator values corresponding to the frequency.
• Frequency Range: 950 ~ 1700 MHz(@ 50 MHz step)
• Attenuator Range: 0 ~ 31.5 dB
ü Step 8: Line-up Test
Perform a line-up test by the satellite operator to confirm antenna performance and operation status.
(Option 1: Using iDirect Open AMIP Modem)
1
2
3
5
BUC M&C** Compensation Method
IF signal Source: iDirect
O
Output Power monitor: BUC M&C
IF signal Source: iDirect
X
Output Power monitor: Stacker
IF signal Source: De-stacker
O
Output Power monitor: BUC M&C
IF signal Source: De-stacker
X
Output Power monitor: Stacker
Compensation path
Full path Calibration
Exclude calibration:
BUC
Exclude calibration:
Modem to ACU Cable
Exclude calibration:
Modem to ACU Cable, BUC
Description
1. Check modem status for connection
readiness by clicking the "Check
Modem
connect to iDirect Open AMIP
modem
Connect" button.
2. Enter the "RF Uplink Frequency"
received
operator
and
This menu can be edited when the
antenna is connected to iDirect Open
AMIP modem and the CW is off.
3. Adjust the "Transmit Power" of
the frequency using the arrow keys
which increases or decreases by
0.5dBm.
4. Adjust the "Antenna Angle".
5. Enter
received from the satellite operator
and click the "Apply" button.
If you have no problems, click the
"Next" button.
55
Operating Install Wizard
Status" button.
by clicking the
from the satellite
through communication
click the "Apply" button.
Result"
the "Test
Then
"CLI
value