Mounting; Orientation; Rigging - Chauvet Home Safety Product User Manual

Mounting

Orientation

Rigging

3. Setup
The Sweeper™ LED may be mounted in any position, provided there is adequate room for
ventilation.
Be sure that the structure can support the weight of the fixture. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. Mount the fixture securely.
This may be done with a screw, nut and bolt, or a mounting clamp.
The hole in each bracket is 13 mm in diameter.
When rigging, consider routine maintenance and control panel access. Please see the following
notes on installation.
·
If the power link out is intended to be used with multiple fixtures, take into account the
length of each power cable, and mount the fixtures close enough to one another to
accommodate for this.
·
When aiming the fixtures, use the bracket/yoke adjustment knobs. Loosen the knobs,
adjust to the desired angle, and then tighten the knobs by turning them clockwise. Do
not use tools for this step, as it may cause damage.
·
Safety cables must always be used!
Hanging Bracket
Bracket Adjustment
Knob
Rubber Feet (4)
7 1/12/2011 11:51 AM