Table of Contents
Advertisement
DSL-2730E User Manual
The following table describes the parameters in this page.
Field
Choose the working mode of the modem. You can
choose from the drop-down list.
Band
Choose the network model of the modem, which is
Mode
varied according to the software. By default, the
network model of the modem is AP.
The service set identification (SSID) is a unique name
to identify the modem in the wireless LAN. Wireless
SSID
stations associating to the modem must have the same
SSID. Enter a descriptive name that is used when the
wireless client connecting to the modem.
Choose a channel from the drop-down list box.
A channel is the radio frequency used by 802.11b/g
wireless devices. There are 13 channels (from 1 to 13)
available depending on the geographical area. You
Channel
may have a choice of channels (for your region) and
Number
you should use a different channel from an adjacent AP
to reduce the interference. Interference and degrading
performance occurs when radio signal from different
APs overlap.
You can choose the transmission power of the radio
Radio Power
signal. The default one is 100%. It is recommended to
(Percent)
choose the default value100%.
Show Active
Click it to view the information of the wireless clients
Clients
connected to the modem.
Select the appropriate band of 20MHZ or 40MHZ
Channel Width
according to your subscribed broadband service.
Control
Choose the channel selection mode as Upper or
Sideband
Lower.
Description
32
Advertisement
Table of Contents
