Table of Contents
Advertisement
DSL-2730E User Manual
The following table describes the parameters of this page.
Field
Default Route
You can select Auto or Specified.
Selection
The virtual path between two points in an ATM
VPI
network, ranging from 0 to 255.
The virtual channel between two points in an ATM
VCI
network, ranging from 32 to 65535 (1 to 31 are
reserved for known protocols)
Encapsulation
You can choose LLC and VC-Mux.
You can choose 1483 Bridged, 1483 MER, PPPoE,
Channel Mode
PPPoA, 1483 Routed or IPoA.
Select it to enable Network Address Port Translation
(NAPT) function. If you do not select it and you want
Enable NAPT
to access the Internet normally, you must add a
route on the uplink equipment. Otherwise, the
access to the Internet fails. Normally, it is enabled.
You can enable or disable Internet Group
Enable IGMP
Management Protocol (IGMP) function.
You can select Disable or Enable. If enabled, you
802.1q
need to enter the VLAN ID.
VLAN ID
The value ranges from 1 to 4095.
When any channel mode except 1483 Bridged is
IP Protocol
selected, select an IP protocol from IPv4/IPv6, IPv4
and IPv6.
PPP Settings
Enter the correct user name for PPP dial-up, which
User Name
is provided by your ISP.
Enter the correct password for PPP dial-up, which is
Password
provided by your ISP.
You can choose Continuous, Connect on
Type
Demand or Manual.
If the type is set to Connect on Demand, you need
Idle Time (min)
to enter the idle timeout time. Within the preset
minutes, if the router does not detect the flow of the
Description
25
Advertisement
Table of Contents
