Charging The Built-In Battery/Setting The Time Code; Charging The Built-In Battery; Setting The Time Code; Specifying The Time Code ([Tc Preset] Item) - Panasonic AG-AC160A Operating Instructions Manual

Charging the built-in battery/setting the time code

Charging the built-in battery

The camera uses the built-in battery to remember
the date and time.
If [LOW INTERNAL BATTERY] (built-in battery level
is low) is displayed when the date and time are
set, it means that the built-in battery is depleted.
Charge the battery with the following method.
Set the date and time after the battery fully
charged.
1
Connect an AC adaptor to the camera.
(Page 27 of Vol.1)
• Leave the POWER/MODE switch of the
camera at <OFF>.
2
Leave the camera for approximately four
hours.
• The built-in battery is charged.
• Check the time code and menu operations
after charging.
If the date and time are not remembered after
charging, the built-in battery needs to be replaced.
Consult your dealer.

Setting the time code

Perform various time code related settings with the
following items on the setup menu [TC/UB SETUP]
screen. (Page 91)
• [TC MODE] item
• [TCG] item
• [TC PRESET] item
• [UB MODE] item (DV mode only)
Specifying the time code ([TC
PRESET] item)
Set the time code value with the [TC PRESET]
item to record any value as the time code value at
the start of recording.
1
Turn the POWER/MODE switch of the
camera <ON>. (Page 30 of Vol.1)
2
Select the [TC PRESET] item on the setup
menu [TC/UB SETUP] screen.
• Menu operation (Page 31 of Vol.1)
• Operations can be performed with buttons on
the remote control that correspond to those on
the camera. For details, see "Remote control"
(Page 24 of Vol.1).
3
Tilt the OPERATION lever in the < >
direction to move to [YES], and push the
OPERATION lever.
51