Depth Gauge - Makita M8101K Instruction Manual

ASSEMBLY
Installing side grip (auxiliary handle)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the side grip.
1
2
3
4
6
5
011089
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Installing or removing drill bit
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the bit.
For Model M8100
1
2
011090
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly. To remove the bit,
turn the chuck key counterclockwise in just one hole,
then loosen the chuck by hand.
After using the chuck key, be sure to return it to the
original position.
For Model M8101
1. Grip base
2. Teeth
3. Side grip (auxiliary
011095
handle)
Hold the ring and turn the sleeve counterclockwise to
4. Protrusion
open the chuck jaws. Place the bit in the chuck as far as it
5. Loosen
will go. Hold the ring firmly and turn the sleeve clockwise
6. Tighten
to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve
counterclockwise.

Depth gauge

011091
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the grip base. Adjust the depth
gauge to the desired depth and tighten the side grip.
1. Drill chuck
2. Chuck key
NOTE:
The depth gauge cannot be used at the position where
the depth gauge strikes against the gear housing.
5
1
1
2
3
1. Sleeve
2. Ring
2
1. Side grip
2. Depth gauge
3. Grip base