Depth Gauge - Makita HP2010N Instruction Manual

CAUTION:
• Always set the speed change lever fully to the
correct position. If you operate the tool with the
speed change lever positioned halfway, the tool
may be damaged.
• Do not use the speed change lever while the
tool is running. The tool may be damaged.
Selecting the action mode
► 1. Change ring
This tool has an action mode changing ring.
For rotation with hammering, turn the ring in the direc-
tion of multiple arrow indication.
For rotation only, turn the ring in the direction of single
arrow indication.
CAUTION:
• Always turn the change ring fully to your desired
mode mark. If you operate the tool with the ring
halfway, the tool may be damaged.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle)
Always use the side grip to ensure operating safety.
Install the side grip on the tool barrel. Then tighten the
thumb screw securely at the desired position. It may be
swung 360° so as to be secured at any position.
Installing or removing drill bit
1
► 1. Chuck key
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.

Depth gauge

► 1. Depth gauge 2. Clamp screw
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the clamp screw and adjust
the depth gauge to the desired depth. After adjusting,
tighten the clamp screw.
NOTE:
•
5 ENGLISH
1
The depth gauge cannot be used at the position
where the depth gauge strikes against the tool
body.
1
2