Azden 35HT Instruction Manual page 5

④ CHANNEL UP and DOWN Button
To change the channel number, use a small, sharp object, such as the tip of a pen, and
press the UP or DOWN button until the desired channel number is shown on the LCD
Display. Keep the button pressed down to fast forward the channel numbers. Once the
desired channel number is selected on the receiver, set the transmitter to the same
number.
⑤ PHONE Jack
This jack allows you to monitor the sound.
⑥ MIC OUT Jack
The 310UDR is supplied with both mini-to-mini and mini-to-dual XLR cables.
For mini jack microphone inputs: Use the supplied mini-to-mini cable. Plug one
end of the cable into the 310UDR Receiver and the other end into the micro-
phone input of the video camera.
For 3-pin XLR microphone inputs: Use the supplied mini-to-dual XLR cable. Plug
the mini-plug end of the cable into the 310UDR Receiver (use the screw-down
sleeve to secure it to the receiver) and plug the XLR ends into the microphone
inputs on the video camera.
⑦ Battery Compartment
Remove the battery compartment lid by sliding it down. Install two fresh alkaline "AA"
batteries. Make sure the battery polarity is correct as marked inside the battery com-
partment. Alkaline batteries are preferred, but Azden's 1HR-3U rechargeable Ni-MH
batteries may be used.
5