Page 1
330 SYSTEM 330 UPR(L)•35BT•35HT•35XT DUAL-CHANNEL ON-CAMERA UHF WIRELESS MICROHONE SYSTEM USER MANUAL Thank you for choosing products of Azden. Before start using this product, you should first thoroughly read this manual. This manual should be kept for future reference.
Page 2
Below shows the description of each part of goods. ①Antenna Azden original antenna For keeping the original performance, don't move the antenna. ②Channel power switch CH1 is for Channel 1 power on/off and CH2 is for Channel 2.
Page 3
Obtain AA alkaline batteries 2 pcs. Using Azden recommending re-chargeable batteries,get AC/DC adapter for recharging from Azden and charge batteries for 8 hours to get full charge. To make sure the batteries at full level, check three bar on the LCD is indicated.
OPERATION FLOW Connect the standard packed cable “stereo mini plug - dual XLR” . Connect the stereo mini plug side to the receiver and the dual XLR side to video camera. The dual XLR side, CH1 is white color marking and CH2 is black color marking. Make sure matching channel set between the receiver and video camera.
Page 5
INTRODUCTION BODY PACK TRANSMITTER (35BT) - Refer the drawing on page 6 - ⑪Remove the battery compartment lid by sliding it down. ⑫Insert two fresh "AA" Alkaline batteries* into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment. In addition to the battery, inside the battery compartment you will find.
Page 6
INTRODUCTION MIC Connector/Locking Ring This 3-pin XLR connector is the microphone input. Any low impedance microphone with a corresponding connector can be attached here. Once the microphone is plugged into the 35XT the locking ring should be rotated clockwise until snug. To remove the microphone, first rotate the locking ring counterclockwise and then, while pressing the XLR release, pull the microphone away from the 35XT.
OPERATING THE SYSTEM Because this is a frequency agile system, the receiver and transmitter must be on the same channel number. To change the channel number, use the tip of the provided tool and press the UP or DOWN button to the desired channel. Make sure both the receiver and transmitter are on the same channel.
Page 9
“UP” button), or to ch070 or lower (Press “DOWN” button) until CH2 display light a lamp. Important information Licensing of this, or any Azden wireless equipment is the user's responsibility. The ability to receive a license depends largely on the user's classification, application and frequency.
CONFIGURATION OF THE PACKAGES The contents of each package are described below. Package: 330LT Description Quantity 330UPR Dual-Channel Receiver Audio cable (XLRx2 – Stereo Mini plug) Audio cable (Stereo Mini plug -Stereo Mini plug) Velcro (Attaching receiver to portable mixer or camera) 35BT Transmitter Livelier microphone EX-50 Package: 330LH...
(at Azden s sole discretion), within two years from the date of purchase. The cost to ship a failed product to and from Azden or to its dealer shall not be covered by this warranty. A dated receipt acts to establish the date of purchase and no registration is necessary to receive warranty service.