Table of Contents
Advertisement
4.2. Fitting the pulling device and adjusting the fitting
angle correctly
Adjust the intermediate sub-frame of the StreetJet to the
appropriate width
Measured width
220-275 mm
275-330 mm
330-425 mm
NOTE:
•
A straight section of the frame tube at a minimum of
45mm is necessary for the attachment of the clamps.
•
The optimal angle of the StreetJet to the ground is 80°.
For optimal performance, it is recommended not to fall
•
below the 340mm minimum mounting height (measured
from floor to bottom edge of the clamp):
Adjusting the subframe to the right front frame width
and angle
NOTE: Make sure that the frame tube diameter is already
adjusted (see section 4.1)
•
Loosen the Screws (A) and (B) of the clamps
12
There are three different front
frame width ranges available to
fit your individual wheelchair
measurements. Measured from
inside tube to inside tube.
•
Loosen the Screws (C) of the subframe
•
Move the StreetJet in front of the wheelchair
•
Close the clamps by pushing on the lever
Empulse StreetJet Rev.A
Advertisement
Table of Contents
