Sunrise Medical Empulse StreetJet Instructions For Use Manual page 13

• Make sure that the clamps are positioned on a
straight section of the tube (min 45mm) and there is
no interference with any part of the wheelchair
• If there is not enough straight tube length, please
adjust the height of the clamps by reposition the
docking arm height
• Open the screws (D)
• Reposition the docking arms
• Tighten the screws (D) by 16Nm.
• Tighten the screws (C) to 20Nm
Empulse StreetJet Rev.A
• Make sure that the distance between mounting plate
and clamp does not exceed 20mm.
Ensure that there is in any case, no contact between the
driving wheel/ stand and the footboard/ feet. (see section
5.0)
• If there is in any case a contact between the driving
wheel and the footboard/ feet please, position the
StreetJet that there in any case no contact between
the driving wheel and the footboard/ feed
• If there is in any case a contact between the stand
and the footboard. The position of the StreetJet stand
must be adjusted. This is done by removing the M6
bolt and nut and repositioning the stand into the
second adjustment hole. The bolt and nut can then
be tightened to 12Nm to secure the stand in place.
• Tighten the screws (A) to 24Nm and (B) to 16Nm
13