Names Of Each Part - Hitachi CPX2(M1-20ML) Service Manual

3. Names of each part

Projector
(1) Lamp cover
The lamp unit is inside.
(2) Focus ring
(3) Zoom ring
(4) Control panel
(5) SD card slot cover
(6) Elevator knobs (x 2)
(7) Elevator feet (x 2)
(8) Lens
(9) Lens cover
(10) Intake vents
(11) Filter cover
The air filter and intake vent are
inside.
(12) Speaker
(13) Exhaust vents
(14) AC inlet
(15) LAN port
(16) USB STORAGE port
(17) USB port
(18) COMPUTER IN port
(19) VIDEO port
(20) S-VIDEO port
(21) Security slot
(22) Shutdown switch
(23) AUDIO OUT port
(24) AUDIO IN port
►HOT!: Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
► Do not look into the lens or vents while the lamp is on, since the strong light is not good
for your eyes.
► Do not handle the elevator knobs without holding the projector, since the projector may
drop down.
► Maintain normal ventilation to prevent the projector from heating up. Do not cover, block or
plug up the vents. Do not place anything that can stick or be sucked to the vents, around
the intake vents. Clean the air filter periodically.
► Do not use the security slot to prevent the projector from falling down, since it is not designed
for it.
► Use the shutdown switch only when the projector is not turned off by normal procedure, since
pushing this switch stops operation of the projector without cooling it down.
All manuals and user guides at all-guides.com
CPX2(M1-20WL)
(7)
(12)
(15)
WARNING
CAUTION
3
HOT! (1) (2) (3)
(10)
(9) (8) (11)
(Bottom)
(13)
(21) (16) (17) (22) (18) (19) (20) (23) (24)
USB STORAGE USB
COMPUTER IN
DC 5V 0.5A
LAN
S-VIDEO
K VIDEO
(4)
(5)
(6)
(7)
(14)
HOT!
AUDIO OUT
AUDIO IN