Hitachi CPX2(M1-20ML) Service Manual page 55

3. Replacing the power units.
You have to remove the
1
dettach the power unit.
Remove the 3 screws to take off the power units.
NOTE : Detaching power unit(circuit)
You have to attach the insulation sheet to the power unit after you replaced the power unit.
Insert between the insulation sheet
and the ballast BKT.
All manuals and user guides at all-guides.com
CPX2(M1-20WL)
Optics unit, Lamp duct and
2
Reuse the Hex-head screw.
1. Remove the screw from old power unit.
2. Attach the screw to new power unit.
55
Lamp house in order of
3
Stick two pieces of the power unit cushion
to power unit when replacing it.
33
Insert into the slit of Insulation sheet.
Put the power unit lead under
the sheet.
Insert between the insulation sheet
and the ballast BKT.
, and before
1 2 3
33