Table of Contents
Advertisement
Names and functions of each part
Main unit
Speaker
Handle
Lens
Cooling fan
(exhaust)
Lens cover Lever
•
Use the remote control transmitter within the range
of about 16 feet from the remote control sensor
and within 30° to both the left and right.
VIDEO input terminal
(on video-equipped models only)
S-VIDEO input terminal
Mini DIN 4pin connector (1/2)
VIDEO input terminal
RCA Jack (1/2)
AUDIO L/R input terminal
RCA Jack (1/2)
MAIN POWER switch
Main power ON/OFF switch.
\: OFF
: ON
8
LAMP indicator
This lights when the
lamp does not light.
(See page 29)
Remote control
sensor
Remote control
Cooling fan
sensor
(in take)
S-VIDEO
VIDEO
AC SW
AC IN socket
Connect the provided
power cord.
INPUT button
To select the input source.
Each time this button is pressed, the input source
is changed in sequence as shown below.
RGB1
RGB2
RGB IN
L
AUDIO
R
AUDIO
AUDIO
IN
OUT
RGB OUT
AC IN
CONTROL
AUDIO output
terminal (RGB/VIDEO)
Stereo mini jack
AUDIO input terminal
Stereo mini jack (1/2)
ON indicator
This blinks in the standby mode
and lights in the operation
mode. (See page 29)
STANDBY / ON
button
Power ON/OFF button.
OFF sets the unit in
standby mode.
(See page 12 ~ 13)
TEMP Indicator
This lights when
temperature inside the
projector is too high. (See
page 29)
MUTE button.
(See page 9)
ZOOM button
Adjusts picture size.
(See page 12)
FOCUS button
Adjusts focus. (See page 12)
MENU button
Picture adjustments.
Refer to page 14 ∼ 18 for
details.
RESET button
Resets unit to factory
settings. (See page 14)
VIDEO1
VIDEO2
RGB input terminal
RGB input terminal
D-sub 15pin shrink
terminal (1/2)
RGB output terminal
RGB output terminal
D-sub 15pin shrink
terminal
RGB output can be displayed
even in the standby mode.
CONTROL terminal
D-sub 15pin shrink terminal
Advertisement
Table of Contents
