POWERWINCH 915 Owner's Manual
  1. Manuals
  2. Brands
  3. POWERWINCH Manuals
  4. Winches
  5. 915
  6. Owner's manual

POWERWINCH 915 Owner's Manual

Boat trailer winch
Hide thumbs Also See for 915:
Table of Contents

Advertisement

Quick Links

Download this manual
B
T
OAT
RAILER
Setup with double line pull (pulley block)
12 Volt Powered Winch
Power-In / Power-Out Operation
Hand Held Wired Remote Control
Thoroughly read the manual furnished with this product and be
familiar with the controls. Do not allow individuals to operate
the winch without understanding the safe operation and
procedures for the equipment.
P7040104r6
W
INCH
Printed in USA
O
'
M
WNER
S
Model 915
pw915101
ANUAL
May, 2022

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 915 and is the answer not in the manual?

Questions and answers

Related Manuals for POWERWINCH 915

Summary of Contents for POWERWINCH 915

  • Page 1 WNER ANUAL Model 915 RAILER INCH Setup with double line pull (pulley block) pw915101  12 Volt Powered Winch  Power-In / Power-Out Operation  Hand Held Wired Remote Control Thoroughly read the manual furnished with this product and be familiar with the controls.

  • Page 2: Table Of Contents

    ROPRIETARY TATEMENT The Powerwinch Trailer Winch is a product of Scott Fetzer Electrical Group or SFEG, located in Fairview, Tennessee, USA. The information contained in or disclosed in this document is considered proprietary to SFEG. Every effort has been made to ensure that the information presented in the document is accurate and complete.
  • Page 3 AFETY NFORMATION The following Safety Precautions Must be Followed at ALL Times. Failure to follow the warnings and cautions in this manual could result in serious injury and/or property damage. WARNING unplug the wiring harness before attempting LWAYS to install, relocate, service or perform maintenance on the winch. WARNING use the winch to lift or move people or animals.

  • Page 4: Specifications

    PECIFICATIONS Various load conditions affect winch performance. The line pull required for a specific application depends on the weight of the load, condition of the trailer rollers, and the degree of the loading ramp incline. The charts below are based on a single line pull and provided as a guideline in calculating pulling capabilities.

  • Page 5: Mounting The Unit

    915 B OWERWINCH RAILER INCH OUNTING THE OUNTING THE The following instructions are for standard mounting of the winch. A quick mount kit is available (p/n P7700000AJ). If installing with the quick mount kit, follow the directions with the kit. Steps 3, 4 and 6 apply when using the kit.

  • Page 6: Wiring The Unit

    915 B RAILER INCH OWERWINCH IRING THE WARNING disconnect the battery before working on LWAYS electrical equipment. WARNING use the recommended wire size and rated circuit LWAYS breakers. Failure to use the furnished and recommended sizes can cause a fire hazard and void warranty.

  • Page 7: Pulley Block

    915 B OWERWINCH RAILER INCH ULLEY LOCK The pulley block can increase the pulling capacity approximately 55%. Assembly Instructions: Place the two screws through one of the tear drop plates and hold in place. Slide a bushing over each screw.

  • Page 8: Operating The Winch

    915 B RAILER INCH OWERWINCH PERATING THE INCH WARNING To avoid personal injury and property damage, clear the area around and behind the boat of people, animals and obstructions before loading or unloading the boat. WARNING Never stand between the load or anchor point and the winch.

  • Page 9: Emergency Hand Crank

    915 B OWERWINCH RAILER INCH MERGENCY RANK An emergency hand crank is available when there is no power (i.e. a dead battery). WARNING Never use the hand crank to assist a running motor. Serious personal injury can occur. Disconnect the power cord from the winch.

  • Page 10: Adjusting The Brake

    PW915013 EPLACING THE ABLE WARNING Always use the exact Powerwinch replacement cable (p/n P7188800AJ). Winch rating and cable strength are matched for safe and optimum performance. NEVER replace the cable with rope. CAUTION wear leather gloves when handling the cable.

  • Page 11: Troubleshooting Guide

    915 B OWERWINCH RAILER INCH ROUBLESHOOTING UIDE INCH PERATE A. Confirm power to winch 1. Check vehicle battery is fully charged 2. Confirm connections are for tight & clean. Correct as required. 3. Check wires are worn or bare that may cause shorts B.

  • Page 12: Replacement Parts List

    915 B RAILER INCH OWERWINCH EPLACEMENT ARTS pw915501...
  • Page 13 915 B OWERWINCH RAILER INCH Item Description Description Notes P7188800AJ Cable Assy, 7/32" x 40' R001304 Cover Kit P5594700AJ Emergency Hand Crank P7904300AJ Pulley Block Kit P7700000AJ Quick Mount Kit R001310 Motor Assy R001487 Relay Module R001305 Remote Control Assy...

  • Page 14: Warranty

    OWERWINCH ARRANTY SFEG warrants to the retail Purchaser that the Powerwinch Product described in this FIRST manual is free of defects in material and workmanship within the terms and conditions as set forth below. SFEG’s obligation under this warranty is limited to the repair or replacement, at SFEG's option, of any defective component within the stated warranty period.
  • Page 15 915 B OWERWINCH RAILER INCH ECORDS EALER NSTALLER DDRESS HONE URCHASE UMBER ERIAL UMBER RODUCT ESCRIPTION Retain your original proof of purchase. It is requi for all warranty repairs and returns. NOTES:...

Table of Contents