Toro Workman UTX Operator's Manual page 85

Removing the Battery
WARNING
Incorrect battery cable routing could damage
the machine and cables, causing sparks.
Sparks can cause the battery gases to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
1. Disconnect the battery cables
Figure 94
1. Negative battery cable
(black)
2. Positive battery cable (red) 5. Nuts
3. Insulator boot (positive
battery cable)
2. Loosen the locknut securing the battery retainer
and remove the battery from the tray
(Figure 94).
g357128
4. Bolt
(Figure 95).
1. Locknut
Installing the Battery
1. Place the battery on the battery tray and secure
the battery to the retainer by tightening the
locknut (Figure
2. Connect the battery cables
85
Figure 95
2. Battery retainer
95).
(Figure 94).
g388241