Pre-Maintenance Procedures; Preparing The Machine For Maintenance; Raising The Machine - Toro Workman UTX Operator's Manual

Pre-Maintenance
Procedures
Preparing the Machine for
Maintenance
1. Park the machine on a level surface.
2. Shift the transmission lever to the P (P
position.
3. Raise and empty the cargo bed.
4. Shut off the engine and remove the key.
5. Allow the machine to cool before performing
maintenance.
6. Disconnect the negative (-) battery cable from
the battery post.

Raising the Machine

DANGER
A machine on a jack may be unstable and slip
off the jack, injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack, as the engine vibration or
wheel movement could cause the machine
to slip off the jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is on a
jack.
When jacking up the front of the machine, always
place a wooden block (or similar material) between
the jack and the machine frame.
The jacking point at the front of the machine is located
at the front frame bottom plate
)
ARK
(Figure 76).
1. Front jacking point
The jacking point at the rear of the machine is located
at the rear cradle bracket
1. Rear jacking point
74
Figure 76
(Figure 77).
Figure 77
g365613
g365614