Appendix E - Usb Data Output (If Equipped) - Omega HHF143 User Manual

APPENDIX E - USB DATA OUTPUT (IF EQUIPPED)

If the instrument is equipped with the USB Communications option, there
will be a four pin male connector on the bottom of the i i nstrument. Also, a
USB cable will be included with the instrument. This cable
four pin female connector on one end and a USB Type-A connector on
the other end.
USB Data Output - Instructions for Use
STEP 1: Install a Virtual COM Port (VCP) Driver on your computer.
Free VCP drivers can be downloaded for Windows, Linux, and
MAC from FTDI Ltd on their website:
http://www.ftdichip.com/DriversNC P .htm
We recommend downloading the setup exe1 c utable, which
automatically runs and configures the drivers for you.
STEP 2: Connect the USS cable (included) to the male connector on
the bottom of your instrument. Connect the, other end to a
USB port on your computer.
STEP 3: Turn the Instrument ON.
STEP 4: Verify that the Instrument has been set up as a USB Serial
Port with a unique COM port number. (You only need to do
this once)
For Windows users, open the Windows Device Manager
(found in Control Panel) and verify that a USS serial port exists
as shown below.
will
have a
Hev 1.8, 1 0-Jun-2008
Page 13 of24