Table of Contents
Advertisement
ENGLISH (Original instructions)
SPECIFICATIONS
Collet chuck capacity
Plunge capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Model
-1
)
Overall height
Net weight
Safety class
equipment
and
environmentally
compatible
) : 89 dB(A)
pA
) : 100 dB(A)
WA
END201-5
Vibration
The
vibration
determined according to EN60745:
Work mode : cuttig grooves in MDF
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
its
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENE010-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENF002-1
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We
Makita
manufacturer declare that the following Makita
machine(s):
ENG102-3
Designation of Machine:
Router
Model No./ Type: RP0900
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
2
RP0900
6mm, 1/4", 8 mm and/or 3/8"
0 - 35 mm
27,000
217 mm
2.7 kg
/II
total
value
(tri-axial
) : 4.0 m/s
h
2
Corporation
as
ENG223-2
vector
sum)
2
ENG901-1
ENH101-13
the
responsible
Advertisement
Table of Contents
