Maintenance - Makita RP0900X/2 Instruction Manual

NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Dust nozzle set (Accessory)
1. Dust nozzle
2. Thumb screw
009754
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
009755

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
1
2
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Templet guide 25
•
Templet guides
•
Templet guide adapter
•
Lock nut
•
Collet cone 3/8", 1/4"
•
Collet cone 6 mm, 8 mm
•
Wrench 13
•
Wrench 22
•
Dust nozzle set
•
8
or attachments
Only use accessory or
are