Brinkmann 810-1750-S Installation Manual page 20

Step 7
Figure 1 shows valve stem and bezel with the
control knob removed. Take five large stop
plates from the component card and place
them over the main and side burner valve
stems as illustrated (Figure 2). Take the small
stop plate from the component card and place
it over the rotisserie burner valve stem (Figure
3). Verify the tab and the stamped letter on the
stop plates face out. Replace control knobs
when finished.
WARNING: We recommend and request that
you do not remove the control panel in order to
access the valve tips. If you choose to remove
the control panel, you must replace the control
panel bezels exactly as illustrated in Figure 2.
Failure to replace the bezels as illustrated could
lead to personal injury and/or property damage.
Step 8
Carefully replace each burner, making sure
burner openings slide over valve nozzles.
Screw each main burner "foot" down using
screwdriver and screws that were set aside in
Step 4. Replace cotter pin in side burner "foot"
that was set aside in Step 2.
Step 9
Replace warming rack, cooking grills, heat
shields and grease tray.
19
Tab
Figure 1
Tab
Figure 3
Stop Plate
Stop Pin
Figure 2
Stop Plate
Stop Pin
Cooking Grills
Heat Shields
Warming Rack