Brinkmann 810-1750-S Installation Manual page 17

Tab
Figure 1
Stop Plate
Stop Pin
Figure 2
Cooking Grills
Heat Shields
Warming Rack
Step 9
Figure 1 shows valve stem and bezel with
the control knob removed. Take seven large
stop plates from the component card and
place them over the valve stems as illustrated
(Figure 2). Verify the tab and the stamped letter
on the stop plates face out. Replace control
knobs when finished.
WARNING: We recommend and request that
you do not remove the control panel in order
to access the valve tips. If you choose to
remove the control panel, you must replace
the control panel bezels exactly as illustrated
in Figure 2. Failure to replace the bezels as
illustrated could lead to personal injury and/or
property damage.
Step 10
Carefully replace each burner, making sure
burner openings slide over valve nozzles.
Screw each main burner down using
screwdriver and screws that were set aside in
Step 6. Replace two screws in side burner
bracket that were set aside in Step 4.
Step 11
Replace warming rack, cooking grills, heat
shields and grease tray.
Note: Follow directions in the leak testing
section of this manual before using
this grill.
16