The Printer Cannot Be Detected In The Wireless Lan - Canon iP110B Online Manual

The Printer Cannot Be Detected in the Wireless LAN

Make sure that the printer is turned on.
Check1
Make sure that the Wi-Fi lamp is lit on the printer.
Check2
If the Wi-Fi lamp is off, the wireless LAN is disabled.
To enable wireless LAN, press and hold the RESUME/CANCEL button, then release the button when the
POWER lamp flashes 10 times.
Wireless LAN is enabled and the Wi-Fi lamp is lit.
When the printer is connected to the computer temporarily using a USB cable,
Check3
make sure that the USB cable is connected properly.
When you set up the wireless LAN connection or change the wireless LAN settings using IJ Network Tool
through USB connection, make sure that the printer is connected to the computer with a USB cable securely.
Connecting the Printer to the Computer Using a USB Cable
Make sure that the printer setup is completed.
Check4
If not, perform setup according to the instructions on our website.
When using IJ Network Tool, click Update to search for the printer again.
Check5
Canon IJ Network Tool Screen
Make sure that the network settings in the printer are identical with those of the
Check6
access point.
Refer to the instruction manual provided with the access point or contact its manufacturer to check the access
point settings, and then modify the printer settings.
How to Set an Encryption Key
Make sure that there is no obstruction.
Check7
Wireless communication between different rooms or floors is generally poor. Adjust the location of the devices.
Make sure that the printer is not placed far away from the access point.
Check8
The access point is located indoors within the effective range for wireless communication. Locate the printer
within 164 ft. / 50 m from the access point.
Make sure that there is no source of radio wave interference in your vicinity.
Check9
If a device (e.g. microwave oven) using the same frequency bandwidth as the wireless station is placed nearby,
the device may cause interference. Place the wireless station as far away from the interference source as
possible.
Make sure that the network settings of the computer are correct.
Check10
Make sure that the computer can communicate with the access point over the wireless LAN.
Make sure that the firewall of the security software is disabled.
Check11
317