Table of Contents
Advertisement
2.4.2
Installing the 2.5-inch SATA/SAS/NVME storage
device
ESC4000 G4
For the ESC4000 G4, the NVME storage devices may be installed in storage device bay 7
and 8 as shown in the illustration below:
1.
Remove the drive tray.
Refer to section ESC4000 G4 under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on removing the drive tray.
2.
Prepare the SATA/SAS/NVME storage
device and the bundled set of screws.
3.
Place the SATA/SAS/NVME storage
device into the tray (A) then secure it
with four screws (B).
4.
Replace the drive tray.
Refer to section ESC4000 G4 under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on replacing the drive tray.
5.
Repeat steps 1 to 4 to install the other SATA/SAS/NVME storage device.
ASUS ESC4000 G4 Series
2
1
Storage device bay 7 and 8
2-19
Advertisement
Table of Contents
