Table of Contents
Advertisement
2.6.3
Installing a hot-swap SATA/SAS hard disk drive
1.
Release a drive tray by pushing the
spring lock to the right, and then pull
the tray lever outward. The drive tray
ejects slightly after you pull out the
lever.
2.
Firmly hold the tray lever and pull the
drive tray out of the bay.
3.
Take note of the drive tray holes.
Each side has three holes to fit
different types of hard disk drives. Use
two screws on each side to secure the
hard disk drive.
2-18
Chapter 2: Hardware Information
Advertisement
Chapters
Table of Contents
