Table of Contents
Advertisement
SATA Port 1-8
PCH sSATA Configuration
sSATA Controller [Enabled]
Allows you to enable or disable the sSATA Controller.
Configuration options: [Disabled] [Enabled]
Configure sSATA as [AHCI]
Allows you to identify the SATA port connected to Solid State Drive or Hard Disk Drive.
Configuration options: [IDE] [AHCI] [RAID]
Support Aggressive Link Power Management [Enabled]
Allows you to enable or disable the Support Aggressive Link Power (SALP)
Management.
Configuration options: [Disabled] [Enabled]
sSATA Port 1-3
USB Configuration
USB Precondition [Disabled]
Allows you to enable or disable precondition work on USB host controller and root ports
for faster enumeration.
Configuration options: [Disabled] [Enabled]
XHCI Manual Mode [Disabled]
This option is used by validation.
Configuration options: [Disabled] [Enabled]
The following items appears only when the XHCI Manual Mode is set to [Enabled].
USB Per-Connector Disable [Disabled]
Allows you to enable or disable each of the USB physical connectors. Once a
connector is disabled, any USB devices plugged into the connector will not be detected
by BIOS or OS.
Configuration options: [Disabled] [Enabled]
5-26
Port 1-8
Allows you to enable or disable the SATA port.
Configuration options: [Disabled] [Enabled]
Port 1-3
Allows you to enable or disable the SATA port.
Configuration options: [Disabled] [Enabled]
Trunk Clock Gating (BTCG) [Enabled]
Allows you to enable or disable BTCG.
Configuration options: [Disabled] [Enabled]
Enable USB 3.0 pins [Disable all pins]
Allows you to enable or disable USB 3.0 pins or on a per pin basis.
Configuration options: [Select Per-Pin] [Disable all pins] [Enable all pins]
Chapter 5: BIOS Setup
Advertisement
Table of Contents
