Table of Contents
Advertisement
2.4
Storage devices
The ESC8000 G4 Series system supports hot-swap 2.5-inch SATA/SAS/NVME storage
devices. The storage device installed in the storage bay connects to the motherboard SATA/
SAS/NVME ports via the SATA/SAS/NVME backplane.
2.4.1
Installing the 2.5-inch SATA/SAS/NVME storage
device
NVME storage devices are only supported on the top 2 (two) storage bays. If you wish to
install an NVME storage device, ensure to install them to the 2 (two) top storage bays.
To install a 2.5-inch storage device:
1.
Press the spring lock.
2.
Pull the tray lever outwards to remove
the storage device tray.
2-18
Chapter 2: Hardware Setup
Advertisement
Table of Contents
