R&S NGM200 Getting Started page 25

®
R&S NGL200/NGM200
2. Connect the power cable to the socket outlet.
3. Press [Power] key on the front panel.
The instrument performs a system check, boots the operating system, and
starts the R&S NGL/NGM firmware.
By default, all output channels are turned off when the instrument is switched on
to prevent connected loads from being damaged unintentionally.
During startup, the R&S NGL/NGM is loaded with the last saved instrument set-
tings from internal memory. See "Store and Recall" in the User Manual.
To switch off instrument:
1. Press [Power] key.
All current settings are saved to internal memory and the firmware shuts
down.
2. Disconnect the AC power cable from the instrument.
Getting Started 1178.8720.02 ─ 05
Instrument Tour
Switching On the Instrument
22