EN
LED Indications
Red, green, blue rapid blinking
Slow green strobe
Slow red strobe
Rapid red fl ash when exiting
forward programming
Slow blue strobe
Installation
1. Mount the FC6250HX fl ight controller with the servo connector block facing
either forward or aft. The side of the FC2650HX facing the main rotor disc
must be parallel to the rotor disc.
2. Use the included mounting tape (SPMA3032) to mount the FC6250HX fl ight
controller to the airframe.
Connections (Servo and ESC)
Normal Confi guration
Aux1 or
Additional Power
4
Initialization complete
Normal operation
Failsafe
Throttle not low; not in Normal/Hold
Forward programming mode
Servo
A
Servo
Servo
C
B
Tail
Rotor
Servo
RX2
Throttle/
ESC
RX1