Led Indications - Spektrum FC6250HX Manual

Before You Get Started
The FC6250HX flight controller is setup, programmed, and tuned via the
Forward Programming menu on a compatible aircraft Spektrum radio
system.
Visit spektrumrc.com for a list of Forward Programming capable transmitters
and updated transmitter firmware.
• Before entering Forward Programming, engage Throttle Hold.
• Before exiting Forward Programming, lower the throttle to the full stop
position.
• Always exit forward programming before disconnecting the power source
to ensure parameters are saved.

LED Indications

Red, green, blue rapid blinking
Slow green strobe
Slow red strobe
Rapid red flash when exiting forward
programming
Slow cyan strobe
Setup
1. In your transmitter, create a new heli setup as a Normal swash plate type.
Set the Frame Rate to 11ms.
The FC6250HX requires the default new model transmitter configuration.
All channels, other than throttle, must have Reversing set to Normal.
All channels, other than throttle, must have the Subtrim set to 0.
All channels, other than throttle, must have the Travel set to 100/100.
All throttle channel settings occur in the following setup procedures within
the transmitter. If you are using a throttle servo do not connect the servo
until you reach the throttle setup step below.
Configure your desired flight modes, throttle curves and pitch curves per
the respective manufacturer recommendations for the Helicopter, ESC,
Engine, and Transmitter. Note, servo settings pertaining to the cyclic,
collective and tail rotor are included in the FC6250HX setup.
Within your transmitter, enable the Transmitter Gyro function and select
the"Flight Mode Switch" option. Set each flight mode gain to 75% to start.
Initialization complete
Normal operation
Failsafe
Throttle not low; not in Normal/Hold
Forward programming mode
EN
5