Spektrum FC6250HX Manual page 6

EN
Binding
1. Power ON the FC6250HX fl ight controller and press the bind button on each
remote. The remote will begin fl ashing, indicating it is ready to bind.
2. Press the bind button on your transmitter. Lower the throttle stick to the stop
position and power ON the transmitter.
Once the bind process is complete, the remote receiver LED turns solid
orange, indicating the FC6250HX is ready for setup.
The FC6250HX LED will begin fl ashing green, indicating a successful bind.
A red fl ashing LED indicates binding is not successful. Begin the binding
procedure again.
Setup
1. In your transmitter, create a new heli setup as a Normal swash plate type.
Set the Frame Rate to 11ms.
The FC6250HX requires the default new model transmitter confi guration.
All channels, other than throttle, must have Reversing set to Normal.
All channels, other than throttle, must have the Subtrim set to 0.
All channels, other than throttle, must have the Travel set to 100/100.
All throttle channel settings occur in the following setup procedures within
the transmitter. If you are using a throttle servo do not connect the servo
until you reach the throttle setup step below.
Confi gure your desired fl ight modes, throttle curves and pitch curves per
the respective manufacturer recommendations for the helicopter, ESC
Engine and Transmitter. Please take note that the collective pitch range will
be setup within the FC6250HX setup instructions below.
Within your transmitter enable the Transmitter Gyro function and select
the"Flight Mode Switch" option. Set each fl ight mode gain to 75%.
2. In the transmitter menu, select Forward Programming.
The transmitter connects to the fl ight controller, and a menu list displays.
3. Navigate to the Setup Swashplate Output Setup menu again.
4. Set the Frame Rate to the operating frequency specifi ed by your servo
manufacturer.
5. Select the Type menu. Set the swashplate type to match your helicopter's
confi guration. Connect the servos shown on the transmitter and per the
Flight Controller connection diagram.
Select Back, and navigate to the Direction menu.
6. Set the servo reversing to ensure the collective pitch stick moves the
servos in the direction of positive collective.
Select Back to return to the previous menu.
6