Making Adjustments And Selections; Powering Off The Projector - Panasonic PT-TW341RU Operating Instructions (Functional Manual)

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
1) Adjust the focus of the image roughly. (
2) Change the settings of the [Display] menu → [Project way] depending on the installation mode.
( page 50)
x
f Refer to "Navigating through the menu" (x page 43) for the operation of the menu screen.
3) Press the <INPUT/ENTER> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <MEMORY VIEWER/USB DISPLAY>) buttons on the remote
control to select the input signal.
4) Adjust the front and back tilt of the projector with the adjustable feet. (
5) Press the <AUTO SETUP> button on the remote control.
6) Adjust the focus with the focus ring.

Powering Off the Projector

1) Press the power <v/b> button on the control panel or on the remote control.
f The following message appears.
2) Press the power <v/b> button on the control panel or on the remote control again.
f Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> blinks in red. (The fan keeps running.)
3) Wait until the power indicator <ON(G)/STANDBY(R)> lights in red.
f The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights in red.
Note
f Do not put the projector in a case before the projector is cooled enough.
f While the power indicator <ON(G)/STANDBY(R)> is blinking in red, the lamp is being cooled down and the projector cannot
be turned on. Wait until the power indicator <ON(G)/STANDBY(R)> lights in red to turn on the projector again.
Chapter 3 Basic Operations - Powering on/off
3)
page 36)
x
3)
1) 2)
5)
3)
page 28)
x
1) 2)
ENGLISH - 35