Table of Contents
Advertisement
Projecting
Check the connections of the peripheral devices (x pages 29 - 31) and connection of the power cord (x page 33) and
switch on the power (x page 34) to start the projector. Select the image and adjust the state of the image.
Selecting the input signal
Select an input signal.
1)
Press the <INPUT/ENTER> button on the control panel or the input selection (<COMPUTER 1>, <COMPUTER 2>,
<HDMI>, <VIDEO> or <MEMORY VIEWER/USB DISPLAY>) buttons on the remote control.
f The image of the signal being input in the selected terminal is projected.
Attention
f Images may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select a
system format that is suitable for the input signal in [Display] menu → [System] (x page 50).
f Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Display] menu →
[Aspect] (x page 49).
How to adjust the state of the image
When setting up the projector for the first time or setting up at a new place, you must perform the following operations.
1)
Adjust the projection angle.
f Install the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screen
is rectangular.
f For details, see "Adjusting adjustable feet" (x page 28).
2)
Adjust the focus.
f Rotate the focus ring to adjust the focus of the projected image.
Note
f It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f If you adjust the focus, you may need to adjust the size of the image by changing the distance between the screen and the
machine.
f If keystone distortion occurs, see the [Expand] menu → [Keystone] (x page 60).
36 - ENGLISH
Chapter 3 Basic Operations - Projecting
Focus ring
Advertisement
Chapters
Table of Contents
