Table of Contents
Advertisement
Section 3 - Configuration
The setup wizard is designed to guide you through a step-by-step process to configure your new DAP-1620
AC1300 Wi-Fi Range Extender to extend your wireless network and connect to the Internet via a wireless setup process. To set your
DAP-1620 using an ethernet cable, please refer to "Wired Setup Wizard" on page 23.
To access the setup utility for the DAP-1620 AC1300 Wi-Fi Range Extender on
your PC, first connect to the DAP-1620 wirelessly using the Wi-Fi name (SSID) and
password located on the back of your DAP-1620. Then open a web browser and
enter http://dlinkap.local./ in your browser's URL field. You may also enter the IP
address* of the DAP-1620.
* The default IP address is 192.168.0.50. Once your DAP-1620 connects to the host network,
it will be assigned a new IP address based on your network's DHCP settings. You will need
to log in to your router to see what IP address is assigned to your DAP-1620. For multiple
DAP-1620s, go to http://dlinkapxxxx.local. as shown on the included Quick Installation
Card, with "xxxx" being the last four digits of the DAP-1620's MAC address.
If this is your first time logging in to the extender and no connection has been
established, the setup wizard will automatically appear. If the setup process was
not previously completed, then log in to the interface by leaving the password
field blank.
D-Link DAP-1620 User Manual
Wireless Setup Wizard
16
Advertisement
Table of Contents
